Do you need to repair woodwork trim and make it new again without stripping away the quality of the wood? With this article, we’ll show you how you can do that with easy steps.
The tools you would need for this project include the following:
- Paint scraper
- Rubber gloves
- Safety glasses
The materials you would need for this project include the following:
- Spar varnish for sills
- Mineral spirits
- Denatured alcohol
- Oxalic acid
- Synthetic abrasive pads
- Wipe-on polyurethane
- Wood filler
- Wood putty
- Wood stain
Repair Woodwork in 4 Easy Steps
1. Clean the woodwork that needs to be repaired.
First, make sure you are wearing protective gear like rubber gloves, goggles, and a shirt that has long sleeves. Next,wrap a rag around a putty knife to scrub the trim of the wood and prevent alcohol from slopping to the wall. Also, the rag is used in cleaning the wood to get rid of grease and all types of contamination with it being cleaned with alcohol.
Then wash the woodwork so the surface is wet. Clean thoroughly with a sponge that has been dipped for cleaning. After that, rinse it off with a clean dry rag.
2. Scrape and sand badly damaged areas.
Use the paint scraper to get rid of all weathered finish that is not good anymore. Use the paint scraper to carefully remove the old finish. This is way quicker than sandpaper, but if not done carefully, the wood may gouge. Oxalic acid should be used if dark water stains are present on the wood, because sanding and scraping don’t remove dark water stains.
Then make use of water to rinse your bleached wood after a night. Try sanding it with sandpaper and make it match the other woodwork by staining it to repair woodwork trim.
3. Fill small holes after roughening the finish.
Take the wood and rub it with the use of an abrasive pad to make a roughened surface that would be used for the new wood finish. After that, get rid of the dust on the surface of the wood before cleaning a brand-new finish coat to repair woodwork trim.
4. Complete project.
To create the new finishes and roughen the finishes used before properly before continuing. The best choice of finishing pads are synthetic ones. This is as a result of them conforming to profiles, and they are not as rough as sandpaper. Make sure you purchase fine and medium tools from your local hardware store. Make sure you also make use of the pad which makes the finish roughened without getting rid of any finished stain.